How to install Shower Set?

Before installing the Metal Wall Mounted Rain Shower Sets, you need to be ready to use the tools used to install, check the completeness of the faucet accessories, our common accessories include a kidnapper, rubber pads, hoses and so on. Purchase a American Standard Nickle Brushed Faucets and raw material tape with the same specifications from the hardware or plumbing stores. At the same time, clean the water pipes before installation, open the valve, and clean the impurities in the pipes. Then check the accessories of the High Quality Square Shower Head Set for impurities to avoid causing plugging problems during installation.

Before installing the Adjustable Wall Mounted Shower Sets, the main valve of the home-installed waterway should be turned off to avoid construction trouble. First, take the elbow out of the box and wrap the raw material tape around the thin end, more than 10 turns will be enough. Then secure the elbow to the wall, remove the valve and install the leakproof rubber gasket in the water intake hole. Then take out the connecting rod, and mark the hole position with a pen, and drill the hole well with an impact drill. Finally, install the shower on the connecting rod, wrap the raw material belt and fix it. In addition, remember to check whether the shower can be used after installation. As also, you can use a common spanner or pipe clamp to twist the old faucet counterclockwise. Adjustable Wall Mounted Shower Sets with your left hand, and the right hand will wind the raw tape towards the tap's thread clockwise for a few turns, be sure to pay attention to the direction. Otherwise, it will cause water leakage. At the same time, the Universial Polished Treatment Shower Mixer Valve is tightened with a wrench clockwise at the interface of the water pipe. After the construction is correct, the total valve of the water pipe is opened and the faucet can be used normally.

Secondly, what problems should we pay attention to in the installation of shower?
1. At present, the installation of Adjustable Wall Mounted Shower Sets can be divided into two situations. If the shower is dark, the height of the wall outlet center and the ground should be kept about 2.1m, and the distance between the shower switch and the ground is about 1.1m; The height of the flower is about 2m from the ground. In addition, it needs to be customized according to the user's height.
2. In the process of tightening the Metal Wall Mounted Rain Shower Sets, it is necessary to protect the hardware of the faucet. If more careful people, will use thicker cloth, or plastic film, wrapped in the faucet nut position, so that when the faucet, will not be scratched the faucet, can increase the service life of the faucet.
3. On the wall of the toilet, the approximate position of the waterway and the circuit needs to be marked, so that when drilling, the water pipe can be broken to a great extent. In addition, if the hot and cold water pipes are installed, the distance between the two taps should be kept at about 15cm. Although the position can be adjusted appropriately, the error should not exceed 1m.

If you are interested in our thermostat shower set, please click the link:https://www.jenorsanitary.com/